Inspection Procedure 2:
Rear view camera image is not correctly displayed. <Vehicles with display audio (DVD
type)>
caution
Before replacing the display
audio (DVD type), ensure that the power supply circuit, the earth circuit, and the communication
circuit are normal (Check that the voltage is 10 V or more).
COMMENTS ON TROUBLE SYMPTOM
When the screen of rear view camera is not shown even if the shift lever <M/T> or
selector lever <A/T> is "R" (Reverse) position, the rear view camera,
the display audio (DVD type), the wiring harness, connectors, back-up lamp switch <M/T>,
inhibitor switch <A/T> may be defective.
PROBABLE CAUSES
Damaged harness wires and connectors
Malfunction of the rear view camera
Malfunction of the display audio (DVD type)
Malfunction of the back-up lamp switch <M/T>
Malfunction of the inhibitor switch <A/T>
DIAGNOSIS PROCEDURE
STEP 1. Check the display audio (DVD type) operation.
Check if the display audio (DVD type) operates normally and the sound is output.
Q.
Is the check result normal?
Go to Step 2.
Troubleshoot the display audio (DVD type) (Refer to ).
STEP 2. Confirmation the service mode.
Display the "Vehicle Signal Check" screen (Refer to ).
Move the shift lever <M/T> or selector lever <A/T> to
the "R" (reverse) position.
Check that "Shift Position R" is "ON."
Q.
Is the check result normal?
Go to Step 5.
Go to Step 3.
STEP 3. Check the back-up lamp switch <M/T> or inhibitor
switch <A/T>.
Check the continuity of the back-up lamp switch <M/T> or inhibitor
switch <A/T> (Refer to GROUP 22G - Transmission or GROUP 23A - On-vehicle
service, Inhibitor switch continuity check).
Q.
Is the check result normal?
Go to Step 4.
Replace the back-up lamp switch <M/T> or inhibitor
switch <A/T>.
STEP 4. Check of short to power supply, short to earth, and open circuit
in REV line between display audio (DVD type) connector and back-up lamp switch <M/T> or
inhibitor switch <A/T> connector.
Q.
Is the check result normal?
Go to Step 7.
Repair the connector(s) or wiring harness.
STEP 5. Confirmation the service mode.
Display the "External Device Connection Check" screen
(Refer to ).
Check that "Rear Camera" is "OK."
Q.
Is the check result normal?
Go to Step 7.
Go to Step 6.
STEP 6. Check of short to power supply, short to earth, and open circuit
in CACC, CGND, CDET, CMP- and CMP+ line between display audio (DVD type) connector
and rear view camera connector.
Q.
Is the check result normal?
Go to Step 7.
Repair the wiring harness.
STEP 7. Trouble symptom recheck.
Check that the display of rear view camera is shown normally.
Q.
Is the check result normal?
The trouble can be an intermittent malfunction (Refer to GROUP 00 - How
to use Troubleshooting/Inspection Service Points - How to Cope with Intermittent Malfunctions).
Replace the rear view camera temporarily and go to Step 8.
STEP 8. Trouble symptom recheck.
Check that the display of rear view camera is shown normally.