Inspection Procedure A-1: Check the battery power supply circuit to the ETACS-ECU.
caution |
Whenever the ECU is replaced, ensure that the power supply circuit and the earthing circuit are normal.
|
COMMENTS ON TROUBLE SYMPTOM
If the ETACS-ECU functions do not work at all, the ETACS-ECU power supply system, earth system, or ETACS-ECU may have a problem.
PROBABLE CAUSES
- Malfunction of the ETACS-ECU
- Damaged harness wires and connectors
|
STEP 1. Resistance measurement at ETACS-ECU connector (EARTH, SGND terminal)
|
|
(1)Disconnect the connector, and measure at the wiring harness side.
|
|
(2)Measure the resistance between the ETACS-ECU connector (EARTH terminal) and body earth. OK: Continuity exists (2 Ω or less)
|
|
(3)Measure the resistance between the ETACS-ECU connector (SGND terminal) and body earth. OK: Continuity exists (2 Ω or less)
|
|
Q.
Is the check result normal?
|
|
Go to Step 3.
|
|
|
|
Go to Step 2.
|
|
|
|
STEP 2. Check of open circuit in EARTH, SGND line between ETACS-ECU connector and body earth
|
|
Q.
Is the check result normal?
|
|
Intermittent malfunction is suspected (Refer to GROUP 00 - How to Use Troubleshooting/Inspection Service Points - How to Cope with Intermittent Malfunction ).
|
|
|
|
Repair the connector(s) or wiring harness.
|
|
|
|
STEP 3. Voltage measurement at ETACS-ECU connector (ETACS +B terminal)
|
|
(1)Disconnect the connector, and measure at the wiring harness side.
|
|
(2)Check the voltage between the ETACS-ECU connector (ETACS +B terminal) and body earth. OK: System voltage
|
|
Q.
Is the check result normal?
|
|
Go to Step 5.
|
|
|
|
Go to Step 4.
|
|
|
|
STEP 4. Check of short to power supply, short to earth, and open circuit in ETACS +B line between fusible link and ETACS-ECU connector
|
|
Q.
Is the check result normal?
|
|
Intermittent malfunction is suspected (Refer to GROUP 00 - How to Use Troubleshooting/Inspection Service Points - How to Cope with Intermittent Malfunction ).
|
|
|
|
Repair the connector(s) or wiring harness.
|
|
|
|
STEP 5. Retest the system.
|
|
Check that the ETACS-ECU functions work normally.
|
|
Q.
Is the check result satisfactory?
|
|
The trouble can be an intermittent malfunction (Refer to GROUP 00 - How to use Troubleshooting/Inspection Service Points - How to Cope with Intermittent Malfunction )
|
|
|
|
Replace the ETACS-ECU (Refer to ).
|
|
|