Code No. U1150 Fail Info. for vehicle speed
TROUBLE JUDGEMENT
If the ETACS-ECU receives a vehicle speed sensor failure signal from engine-ECU, the ECU sets diagnosis code No. U1150.
PROBABLE CAUSES
- Malfunction of the vehicle speed sensor
- Malfunction of the engine-ECU
- Malfunction of the ETACS-ECU
- Malfunction of the CAN bus
DIAGNOSIS PROCEDURE
STEP 1. M.U.T.-III CAN bus diagnostics
Use the M.U.T.-III to diagnose the CAN bus lines.
Q.
Is the check result normal?
Go to Step 2.
Repair the CAN bus line (Refer to GROUP 54C - Troubleshooting
).
STEP 2. Check the M.U.T.-III Diagnosis code for other systems
Check that the engine-ECU sets a diagnosis code.
Q.
Is the diagnosis code set?
Diagnose the engine-ECU (Refer to GROUP 13A - Troubleshooting
<4G6>, GROUP 13B - Troubleshooting
<4D5> or GROUP 13C - Troubleshooting
<4N1>.
Go to Step 3.
STEP 3. Check whether the diagnosis code is set again.
Check again if the diagnosis code is set in the ETACS-ECU.
|
(1)Erase the diagnosis code.
|
|
(2)Turn the ignition switch from "LOCK" (OFF) position to "ON" position.
|
|
(3)On completion, check that the diagnosis code is set again.
|
Q.
Is the diagnosis code set?
Replace the engine-ECU (Refer to
). After replacing the ECU, carry out the CAN bus diagnostics. Then go to Step 4.
A poor connection, open circuit or other intermittent malfunction is present in the CAN bus lines between the engine-ECU and the ETACS-ECU (Refer to GROUP 00, How to Use Troubleshooting/Inspection Service Points - How to Cope with Intermittent Malfunctions
).
STEP 4. Check whether the diagnosis code is set again.
Check again if the diagnosis code is set in the ETACS-ECU.
|
(1)Erase the diagnosis code.
|
|
(2)Turn the ignition switch from "LOCK" (OFF) position to "ON" position.
|
|
(3)On completion, check that the diagnosis code is not set again.
|
Q.
Is the diagnosis code set?
Replace the ETACS-ECU (Refer to
). After replacing the ECU, carry out the CAN bus diagnostics. Then go to Step 5.
A poor connection, open circuit or other intermittent malfunction is present in the CAN bus lines between the engine-ECU and the ETACS-ECU (Refer to GROUP 00, How to Use Troubleshooting/Inspection Service Points - How to Cope with Intermittent Malfunctions
).
STEP 5. Check whether the diagnosis code is set again.
Recheck if the diagnosis code is set in the ETACS-ECU.
|
(1)Erase the diagnosis code.
|
|
(2)Turn the ignition switch from "LOCK" (OFF) position to "ON" position.
|
|
(3)On completion, check whether the diagnosis code is set again.
|
Q.
Is the diagnosis code set?
Return to Step 1.
The procedure is complete.