MULTIVISION DISPLAY REMOVAL AND INSTALLATION


note When the multivision display is replaced, always turn the ignition switch to the "ON" position once and then carry out the operation check.
Pre-removal Operation
  • Centre upper panel assembly Removal (Refer to GROUP 52A - Instrument Centre Panel ).
  • Outside/Inside Air Selection Damper Control Cable Connection, Air Mixing Damper Control Cable Connection, Mode Selection Damper Control Cable Connection Removal <Manual A/C> (Refer to GROUP 55A - Heater Control Unit ).

 Post-installation Operation
  • Outside/Inside Air Selection Damper Control Cable Connection, Air Mixing Damper Control Cable Connection, Mode Selection Damper Control Cable Connection Installation <Manual A/C> (Refer to GROUP 55A - Heater Control Unit ).
  • Centre upper panel assembly Installation (Refer to GROUP 52A - Instrument Centre Panel ).




Removal Steps


1.
 Multivision display/Bracket


2.
 Bracket (LH/RH)

>>A<<
 3.
 Multivision display


4.
 GPS antenna

INSTALLATION SERVICE POINT


>>A<< MULTIVISION DISPLAY




The connectors, antenna and cables connected to the multivision display are shown in the figure.