|
1.Remove the lock pin
indicated in the figure, swivel the caliper body upward and
retain
it with a wire or similar tool.
|
|
2.Remove the following parts
from the caliper support.
(1)
Shim
(2)
Brake pad assembly
(3)
Clip
|
|
3.
| caution |
Keep grease or other soiling
off the pad and brake disc friction
surfaces.
|
Clean the piston part, and press the piston into the
cylinder using the special tool piston
expander (MB990520).
4.Assemble the shim, brake
pad assembly and clip to the caliper support, and tighten
the lock pin to the specified
torque.
Tightening torque: 44 ± 5
N·m
| note |
Install the brake pad assembly
(with wear indicator) to the inner side of the
brake disc,
making sure that the wear indicator is located
on the top.
|
|
