REMOVAL AND INSTALLATION

Door inside handle removal 1. Door inside handle (Refer to GROUP 52A - Door trim ) Door outside handle removal steps · Front lower sash (Refer to ) 2. Door outside handle Door latch assembly removal steps  1. Door inside handle (Refer to GROUP 52A - Door trim ) 3. Retainer 4. Door lock key cylinder <Driver’s side (vehicles without keyless operation system), Passenger’s side (vehicles with keyless operation system)> 5. Screw <<A>> 6. Door latch assembly <<A>> 7. Door lock cover >>C<< 8. Door inside lock cable >>C<< 9. Door inside handle cable >>B<< 10. Door outside handle rod Door check removal steps · Front door speaker (Refer to GROUP 54A - Speaker ) >>A<< 11. Door check

Door inside handle removal 1. Door inside handle (Refer to GROUP 52A - Door trim ) Door outside handle removal steps · Rear lower sash (Refer to ) 2. Door outside handle Door latch assembly removal steps  1. Door inside handle 3. Screw <<A>> 4. Door latch assembly <<A>> 5. Door lock cover >>C<< 6. Door inside lock cable >>C<< 7. Door inside handle cable 8. Door outside handle rod Door check removal steps · Rear door speaker (Refer to GROUP 54A, Speaker ) >>A<< 9. Door check

Remove the door lock cover in the following procedures: 1.Release the upper and lower claws of the door lock cover by using a flat-tipped screwdriver. 2.Pull the cover out a little. 3.With the cover pulled out state, slide it toward cabled side and remove it from the door latch assembly.

Install the door check with the following identification mark facing upward. Application Identification mark Front door Left door FL Right door FR Rear door Left door RL Right door RR

Install the door outside handle rod so that it is behind the lock/unlock switch wiring harness as shown.

Connect the door inside lock cable and door inside handle cable to the door inside handle according to the identification colour marked on the cables as shown in the illustration.