![](../../../img/51/ACD02216AB00ENG.png)
|
- Remove the washer tank assembly with the washer hose
attached. Then fill the washer tank with
water.
- Check to see that the washer fluid is vigorously
sprayed when connecting the positive battery
terminal to terminal number 2 and terminal number 1
to earth.
|
|
Check the windshield washer switch
from the ETACS diagnosis codes for proper operation (Refer
to GROUP 54A, ETACS ).
|
![](../../../img/51/AC900637AC00ENG.png)
|
note |
Use special tool Adjustment
tool, washer nozzle (MB992326) to adjust the
splashing points of the nozzle.
|
|
![](../../../img/51/AC900640AB00ENG.png)
|
caution |
Adjust the splashing position
within the specified adjustment range, otherwise
the windshield cannot be washed
properly.
|
1.Use special tool Adjustment tool, washer
nozzle (MB992326) to adjust the splashing points of the
nozzle. 2.Insert the jet type washer nozzle
adjusting side of the special tool Adjustment tool, washer
nozzle (MB992326) into the injection part of the washer
nozzle as shown in figure (A).
|
![](../../../img/51/AC900643AB00ENG.png)
|
3.Move the special tool
Adjustment tool, washer nozzle (MB992326) up and down to
adjust the angle of the washer nozzle as shown in figure
(B).
|