SUPPORT LOCATIONS FOR LIFTING AND JACKING


SUPPORT POSITIONS FOR A GARAGE JACK, AXLE STANDS, SINGLE-POST LIFT OR DOUBLE-POST LIFT AND PLATE TYPE LIFT


caution Do not support the vehicles at locations other than specified supporting points. Doing so will cause damage, etc.

Garage jack


caution Never support any point other than the specified one, or that point will be deformed.


Axle stands and a single-post lift or double-post lift


caution
  • If rubber attachments with grooves that are too thick are used at the front support positions, the front fender may become bent, so be sure to use rubber attachments with groove thicknesses of 18 mm or less.

  • If attachments which are not high enough are used, they may damage areas such as the side sill garnish. Be sure to use attachments which are high enough, or remove the side sill garnish if not using attachments.


Plate type lift


caution Insert a spacer between the notch and the lift to avoid damage to the side sill garnish. Be careful not to contact the spacer against the side sill.
Support the notch with a spacer (100-mm width, 100-mm height and 200-mm depth).