|
|
1.Move the selector lever to
the N position.
|
|
|
2.Loosen the adjusting nut,
and set the manual control lever upper and lower to the
free condition.
|
|
|
3.Move the manual control
lever lower to the neutral position.
|
|
4.Loosen the inhibitor
switch body mounting bolts, and then turn the inhibitor
switch body
to align the second hole from the end of the manual control
lever with the hole in the inhibitor
switch body flange (section A - A).
| note |
The inhibitor switch body can
be aligned by hand, because the manual control
lever end
is as wide as the switch body flange.
Alternatively, the inhibitor switch can also be
aligned
by inserting a 5-mm bar in the second hole from
the end of the manual control lever and the
hole in the inhibitor switch body
flange.
|
5.
| caution |
Be careful not let the
inhibitor switch body slip out
of place.
|
Tighten the inhibitor switch body mounting bolt to
the specified torque.
Tightening torque: 11
± 1 N·m
|
|
6.Tighten the transmission
control cable locking nut to the specified
torque.
Tightening torque: 12 ± 2
N·m
7.Check that the selector lever
is at the N position.
8.Check that the
transmission shifts to the correct range corresponding to
the position
of the selector lever, and that it functions correctly in
that range.
|