|
1.The headlamps should be
aimed with the proper beam setting equipment, and in
accordance with the equipment manufacture’s
instructions.
2.Alternately turn the adjusting
screw to adjust the headlamp aiming.
|
|
1.Inflate the tyres to the
specified pressures and there should be no other load in the
vehicles other than driver or substituted weight of
approximately 75 kg placed in driver’s
position.
2.Put the headlamp levelling switch in
"0" position.
3.Set the distance between the
screen and the centre marks of the headlamps as shown in the
illumination.
|
|
4.Check if the beam shining
onto the screen is at the standard
value.
Standard value:
(Vertical direction)
60 mm below horizontal (H)
(Horizontal direction)
15° sloping section intersects the vertical line
(V)
| note |
The illustration shows LH
drive vehicles. For RH drive vehicles, it is
symmetrical.
|
|
|
5.
| caution |
Be sure to adjust the aiming
adjustment screw in the tightening
direction.
|
Alternately turn the adjusting screw to adjust the
headlamp aiming.
|