INSPECTION PROCEDURE P-1: The ignition switch (ACC) signal is not received.


caution Whenever the ECU is replaced, ensure that the input signal circuit is normal.




COMMENTS ON TROUBLE SYMPTOM
Input signal from the ignition switch (ACC) is used to operate the functions below. If the signal is abnormal, these functions will not work normally.

  • Sunroof
  • Windshield wiper and washer
  • Rear wiper and washer
  • Electric retractable remote controlled door mirror
  • Interior lamp automatic-shutdown

POSSIBLE CAUSES

  • Malfunction of the ETACS-ECU
  • Damaged harness wires and connectors

DIAGNOSIS PROCEDURE

Step 1. Connector check: C-219 ETACS-ECU connector


Q. Is the check result normal?

Go to Step 2.

Repair the defective connector.

Step 2. Voltage measurement at the C-219 ETACS-ECU connector.


(1)Remove the ETACS-ECU, and measure at the junction block side.
(2)Ignition switch: ACC position

(3)Voltage between C-219 ETACS-ECU connector terminal No.4 and body earth
OK: System voltage

Q. Is the check result normal?

Go to Step 4.

Go to Step 3.

Step 3. Check the wiring harness between C-219 ETACS-ECU connector terminal No.4 and the ignition switch (ACC).








note Prior to the wiring harness inspection, check intermediate connector C-125, and joint connector C-32 <L.H. drive vehicles> C-01 <R.H. drive vehicles>, and junction block connector C-203, and repair if necessary.

  • Check the power supply line for open circuit.

Q. Is the check result normal?

The trouble can be an intermittent malfunction (Refer to GROUP 00 - How to Cope with Intermittent Malfunction ).

Repair the wiring harness.

Step 4. SWS monitor data list.
<Selected item> ETACS ECU
  • Ignition switch: ACC
Item No.
 Item name
 Normal condition
Item 31
 IG SW(ACC)
 ON
OK: Normal condition is displayed.

Q. Is the check result normal?
The trouble can be an intermittent malfunction (Refer to GROUP 00 - How to Cope with Intermittent Malfunction ).
Replace the ETACS-ECU.