REMOVAL AND INSTALLATION

			Mode selection damper control motor removal step
		·	Front deck cross member and heater unit assembly (Refer to . )
		1.	Mode selection damper control motor
			Front air mixing damper control motor removal step
		·	Cowl side trim (Refer to GROUP 52A, Interior Trim .)
		·	Selector lever, selector lever panel and glove box (Refer to GROUP 52A, Instrument Panel .)
<<A>>	>>A<<	2.	Front air mixing damper control motor
			Outside/inside air selection damper control motor and front power transistor removal step
		·	Cowl side trim (Refer to GROUP 52A, Interior Trim .)
		·	Selector lever, selector lever panel and glove box (Refer to GROUP 52A, Instrument Panel .)
		3.	Front power transistor
		4.	Outside/inside air selection damper control motor
			Front blower motor removal step
		5.	Front blower motor

REMOVAL SERVICE POINT

<<A>> FRONT AIR MIXING DAMPER CONTROL MOTOR REMOVAL

1.Turn the temperature control dial to the MAX COOL position.

2.Turn the air outlet changeover mode to the FACE or FACE/FOOT position, and then turn it to the FOOT position.

3.Cut the water proof cover away from the groove section.

4.Rotate the front air mixing damper control motor to the direction B by approximately 20°, and remove it while pushing the air mixing control link A.

INSTALLATION SERVICE POINT

>>A<< FRONT AIR MIXING DAMPER CONTROL MOTOR INSTALLATION

1.Install the front air mixing damper control motor to the link and rotate it to the direction C by approximately 20°.
2.Temporarily secure the front air mixing damper motor by the screw.

3.Operate the blower by maximum air volume, check the air leak from FACE air outlet. If there is the air leak, rotate the air mix damper control motor to the direction C to prevent the leak.

4.Check that there is the pin at the end of hole. If there is not, move the front air mixing damper control motor so that the pin is positioned at the end of hole.
5.Retighten the screw.

6.Drill in the section shown.

7.Secure the water proof cover with its replacement bracket.