DISASSEMBLY AND REASSEMBLY

			Disassembly steps
		1.	Shaft snap ring
		2.	Shaft inter lock plate
	>>D<<	3.	Spring pin
		4.	Inner No.1 lever shaft
		5.	Compression spring
		6.	Select spring No.2 seat
		7.	Shaft and select lever shaft
		8.	Oil protect plate
		9.	Ring pin
	>>C<<	10.	Shift lever boot
	>>B<<	11.	Oil seal
	>>A<<	12.	Plug
		13.	Control shaft cover

REASSEMBLY SERVICE POINTS

>>A<< BREATHER PLUG INSTALLATION

Using special tool crankshaft adapter (MB992000), install the plug.

>>B<< OIL SEAL INSTALLATION

Using Φ26 mm socket wrench, press fit the oil seal into the control shaft cover.

>>C<< SHIFT LEVER BOOT INSTALLATION

1.Shift lever boot is hooked and attached to the slot on the control cover.

2.Install the shift lever boot so that the embossed mark is in the direction shown in the figure.

>>D<<SPRING PIN INSTALLATION

Using special tool installer lock pin (MD998245), install the spring pin.