![](../../../img/11/AK802572AC00ENG.png)
|
caution |
Loosing the installation bolts
for the camshaft bearing cap at
the same time causes the valve spring force,
which makes the installation bolts jump out,
resulting
in the damaged threads. Gradually loosen them
four or five times, not in one time.
|
Remove the installation bolts of each camshaft
bearing cap in the order
shown in the illustration.
|
|
Apply oil to the entire coupling to
install the coupling to the slit portion
of the exhaust camshaft rear end.
|
|
1.Install the exhaust
camshaft.
|
![](../../../img/11/AK802563AC00ENG.png)
|
2.Align the timing chain
link plate with the timing mark of the exhaust
camshaft to loop the timing chain.
|
![](../../../img/11/AK802564AC00ENG.png)
|
3.Install the inlet
camshaft, Align the timing marks on each camshaft gear
to install them.
|
![](../../../img/11/AK802571AC00ENG.png)
|
1.Apply the liquid gasket to
the rear camshaft bearing cap, as shown in the
illustration. Specified
sealant:
Three bond 1217G or
equivalent
2.Install each
camshaft bearing cap to the cylinder head.
note |
Check the identification codes
regarding the cap No. Check whether it is for
the inlet
side or the exhaust side.
|
Identification mark (stamped on each
camshaft bearing
cap)
I: Inlet side E: Exhaust
side
3.Install a new O- ring to
the oil pipe. 4.Install the oil pipe to the
camshaft bearing cap. 5.Tighten the camshaft
bearing cap bolts to the specified torque in the order shown
in the illustration. Specified
torque
M6: 11 ± 1 N·m M8:
20 ± 1 N·m
|