REMOVAL AND INSTALLATION <6B3>

Pre-removal Operation

Engine Coolant Draining (Refer to GROUP 14 - On-vehicle Service, Engine Coolant Replacement ).
Battery and Battery Tray Removal (Refer to GROUP 54A - Battery ).

Post-installation Operation

Battery and Battery Tray Installation (Refer to GROUP 54A - Battery ).
Engine Coolant Refilling (Refer to GROUP 14 - On-vehicle Service, Engine Coolant Replacement ).

			Removal steps
<<A>>	>>A<<	1.	Hose clip
<<A>>	>>A<<	2.	Radiator upper hose connection
		3.	Harness bracket
		4.	Camshaft position sensor connector connection
		5.	Camshaft position sensor
		6.	O-ring

REMOVAL SERVICE POINT

<<A>> HOSE CLIP/RADIATOR UPPER HOSE DISCONNECTION

1.Make mating marks on the radiator upper hose and the hose clip as shown to install them in the original position.

2.Break off the tip of hose clip claw and spread out the hose clip, then disconnect the radiator upper hose.

note

If there is a hose clip claw, the hose clip cannot spread to capacity because the claw contacts the hose clip.

INSTALLATION SERVICE POINT

>>A<< RADIATOR UPPER HOSE/HOSE CLIP INSTALLATION

1.Insert radiator upper hose as far as the projection of the thermostat housing.
2.Align the mating marks on the radiator upper hose and hose clip.
3.Remove the hose clip claw and shorten the hose clip, then install the radiator upper hose.