|
1.Wipe off the grease on the
shaft spline.
|
|
2.If the PTJ boot is reused,
protect the shaft spline area with a tape from damage in
pulling out the boot.
|
|
1.
caution |
There should be no grease
adhered to the rubber part
of the dynamic damper.
|
Install the dynamic damper in the position (A) shown
in the figure. A: 231 ± 3
mm 2.Secure the damper
band. 3.Wrap plastic tape around the shaft spline,
and then install the PTJ boot band (small)
and PTJ boot.
|
|
Apply a tape to the shaft spline
area, and then incorporate the PTJ boot.
|
|
1.Fill the specified grease
fully into the clearance between the spider shaft of the
spider assembly and the roller. Specified
grease: Repair kit grease
|
|
2.Install the spider
assembly to the shaft of the spline area from the bevelling
side.
|
|
3.Insert the driveshaft into
the PTJ case after filling the specified grease to the PTJ
case, and then fill the grease again. Specified
grease: Repair kit grease Application
amount:
220 ± 10 g <LH
(2400)> 200 ± 10 g <RH
(2400)> 245 ± 10 g <LH
(3000)> 255 ± 10 g <RH
(3000)>
note |
When using the repair kit
grease, fill the half of the grease into the
joint and the other
half into the boot as a guideline, and consume
the grease completely.
|
|
|
Adjust the distance between the
boot bands to the standard value to make the air volume
inside the PTJ boot to the specified value, then be sure to
tighten the PTJ boot band (large)
and PTJ boot band (small). Standard value: 85
± 3 mm
|