|
1.Remove the parts indicated
in the figure, swivel the caliper body upward and retain it
with a wire or similar tool.
|
|
2.Remove the following parts
from the caliper support.
(1)
Shim
(2)
Brake pad assembly (brake pad and wear indicator
assembly)
(3)
Clip
|
|
3.
| caution |
Keep grease or other soiling
off the pad and brake disc friction
surfaces.
|
Clean the piston part, and press the piston into the
cylinder using the special tool piston
expander (MB990520).
|
|
4.Assemble the shim, brake
pad assembly and clip to the caliper support, and tighten
the
lock pin to the specified torque.
Tightening
torque: 44 ± 5 N·m
| note |
Install the brake pad assembly
(with wear indicator) to the inner side of the
brake disc,
making sure that the wear indicator is located
on the top.
|
|
|
1.Remove the two flange
bolts to loosen the caliper body.
|
|
2.Lift the caliper body and
the parking brake rear cable to put them aside.
|
|
3.Remove the following parts
from the caliper support.
(1)
Shim
(2)
Brake pad assembly (brake pad and wear indicator
assembly)
(3)
Clip
|
|
4.
| caution |
Keep grease or other soiling
off the pad and brake disc friction
surfaces.
|
Clean the piston part, and press the piston into the
cylinder using the special tool piston
expander (MB991621).
|
|
5.Assemble the shim, brake
pad assembly and clip to the caliper support, and tighten
the
two bolts to the specified torque as
shown.
Tightening torque: 35 ± 4
N·m
| note |
Observe the followings when
you install the brake pad
assembly:
- Mount the brake pad with the wear
indicator to the inside of the
vehicle.
- Projection behind the brake pad assembly
should be seated in the groove of the
piston.
|
|
