1.Before inspection, set the
vehicle to the pre-inspection condition. 2.Turn the ignition switch to "LOCK" (OFF) position. 3.Connect the M.U.T.-III to the diagnosis connector. |
11.If there is deviation
from the standard value, set the idle mixture to the
specified value
by adjusting the mixture adjusting screw (variable
resister). Use the special tool MAS screwdriver (MD998299) to turn the mixture adjusting screw. 12.Remove the timing light. 13.Turn the ignition seitch to "LOCK" (OFF) position and then disconnect the M.U.T.-III. |