REMOVAL SERVICE POINT |
<<A>> CYLINDER HEAD REMOVAL |
![]() |
Using special tool head bolt wrench
(MD998051), loosen the cylinder head bolts in two or three
steps in the order of the numbers shown in the
illustration. |
INSTALLATION SERVICE POINTS |
>>A<< CYLINDER HEAD GASKET INSTALLATION |
1.
|
![]() |
2.Assemble to the cylinder
block so the cylinder head gasket identification mark is at
the top surface. |
>>B<< CYLINDER HEAD ASSEMBLY INSTALLATION |
1.
|
![]() |
2.
(1) Tighten the cylinder head bolts to 108 ± 5 N·m in the order shown. (2) Loosen the bolts fully in the reverse order of that shown. (3) Tighten the cylinder head bolts to 108 ± 5 N·m in the order shown. |