|
Using special tool head bolt wrench
(MD998051), loosen the cylinder head bolts in two
or three steps in the order of the numbers shown in the
illustration.
|
|
1.
caution |
Do not allow any foreign
materials get into the coolant passages, oil
passages and cylinder.
|
Degrease the cylinder head gasket mounting
surface.
|
|
2.Assemble to the cylinder
block so the cylinder head gasket identification mark is at
the
top surface.
|
|
1.
caution |
Be careful that no foreign
material gets into the cylinder, coolant
passages
or oil passages. Engine damage may
result.
|
Use a scraper to clean the gasket surface of the
cylinder head assembly.
|
|
2.
caution |
Install the head bolt washers
with the bevelled side facing upwards as
shown in the illustration.
|
Use special tool head bolt wrench (MD998051) to
tighten the cylinder head bolts as follows: (1)
Tighten the cylinder head bolts to 108 ± 5 N·m
in the order shown. (2)
Loosen the bolts fully in the reverse order of that
shown. (3)
Tighten the cylinder head bolts to 108 ± 5 N·m
in the order shown.
|