|
1.Remove the engine oil pan
mounting bolts.
|
|
2.
caution |
Do not use special tool oil
pan FIPG cutter (MD998727) in area A of the
engine oil pan.
Using the special tool (MD998727) in area A may
cause deformation of the front case because
the front case is made of aluminium.
|
Tap special tool (MD998727) into the range B between
the cylinder block and the engine
oil pan, and then slide the tool sideways.
note |
If any surrounding parts
interfere with the removal, there is no need to
use the special
tool (MD998727).
|
3.With the engine oil pan separated from the
cylinder block, remove the engine oil pan
strainer mounting bolts, and then remove the engine oil pan
together with engine oil pan strainer.
|
|
1.Remove sealant from the
engine oil pan and cylinder block surfaces.
|
|
2.Apply the specified
sealant to the mating surface of the timing gear case and
crankcase. Specified sealant: MITSUBISHI
GENUINE PART MD970389 or equivalent
note |
Install the engine oil pan
within 15 minutes after applying
sealant.
|
|
|
3.Apply the specified
sealant to the engine oil pan mating surface as
shown. Specified sealant: MITSUBISHI GENUINE
PART MD970389 or equivalent 4.
caution |
Then wait at least one hour.
Never start the engine or let engine oil
or coolant touch the sealant surface during that
time.
|
Tighten the engine oil pan mounting bolts to the
standard torque.
|
|
Replace the gasket with a new
gasket. Install the new gasket in the direction shown in
the illustration.
|