|
1.Remove the engine oil pan
mounting bolts.
|
|
2.
caution |
Do not use the special tool
oil pan FIPG cutter (MD998727). It will damage
the engine oil pan (aluminium made).
|
Screw the bolts (M10 × 1.25) into the bolt
holes of engine oil pan shown in the figure, then remove the
engine oil pan.
|
|
1.Remove sealant from the
engine oil pan and cylinder block surfaces.
|
|
2.Degrease the
sealant-coated surface and the engine oil pan mating surface
of the cylinder block.
|
|
3.Apply a bead of the
sealant to the cylinder block mating surface of the engine
oil pan as shown. Specified sealant: MITSUBISHI
GENUINE PART MD970389 or equivalent
note |
Install the engine oil pan
within 15 minutes after applying
sealant.
|
4.Install the engine oil pan to the cylinder
block. 5.
caution |
- The bolt holes for bolts 13 and 14 in
the illustration are cut away on the
transmission side. Be careful not to
insert these bolts at an angle.
- Then wait at least one hour. Never start
the engine or let oil or coolant touch
the sealant surface during that
time.
|
Tighten the engine oil pan mounting bolts to the
specified torque in order of the numbers shown in the
illustration. Tightening torque: 8.5 ±
3.5 N·m 6.Tighten the engine oil pan
mounting bolts of the transmission connection side to the
specified torque Tightening torque: 36 ±
5 N·m
|