|
|
If the tie rod end is disengaged
from the knuckle, renew the tie rod end dust cover and
retainer by following the procedure below.
|
|
|
1.Unclip the clip ring to
remove the dust cover.
|
|
2.
| caution |
Be careful not to damage the
ball joint stud.
|
Use a flat-tipped screwdriver to remove the
retainer.
|
|
3.Apply multi-purpose grease
to the new retainer, and assemble it to the new dust
cover.
|
|
4.Fill multi-purpose grease
inside the dust cover as shown.
Amount to use:
4 ± 1g
5.Apply multi-purpose grease
to the dust cover lip.
6.Tape the stud threads to
avoid damage.
|
|
7.
| caution |
Ensure grease does not come
into contact with the ball joint threads and
tapers. Wipe off the grease if
contaminated.
|
Install the ball joint to the dust
cover.
8.Secure the dust cover with the clip
ring.
|