GARNISHES

DOOR GARNISH REMOVAL AND INSTALLATION

		Front door garnish removal steps
		1.	Front door garnish
		2.	Front door cushion <vehicles for GCC>
		Rear door garnish removal steps
<<A>>	>>A<<	3.	Rivet A
		4.	Rear door garnish
<<A>>	>>A<<	5.	Rivet B
		6.	Rear door garnish pad
	>>B<<	7.	Protect film <vehicles without side step>

REMOVAL SERVICE POINT

<<A>> RIVETS A/RIVETS B REMOVAL

Refer to the Disassembly Service Point for FRONT BUMPER. (

)

INSTALLATION SERVICE POINTS

>>A<< RIVETS A/RIVETS B INSTALLATION

Refer to the Reassembly Service Point for FRONT BUMPER. (

)

>>B<< PROTECT FILM INSTALLATION

1. Installation position
2.

caution

The ambient temperature should be 20 to 38°C. Ensure that the working area is clean.
If ambient temperature is less than 20°C, heat the protect film and application surface to a temperature of 20 to 30°C.
Be careful that air bubbles are not formed under the protect film.

Installation procedure
(1) Wipe the protect film application surface and clean it with a rag moistened with isopropyl alcohol.
(2) Remove backing paper from the protect film, and apply the film to the specified position.

LICENCE PLATE GARNISH REMOVAL AND INSTALLATION

caution

When the licence plate carrier assembly is released and opened, always insert a pin to the right-side hinge to fix the carrier.

		Back door garnish removal
		1.	Back door lower garnish (LH and RH)
		2.	Rear fog lamp connector connection
		3.	Rear fog lamp
		4.	Corner sensor
		5.	Licence plate garnish
		·	Back door trim (Refer to GROUP 52A, Back door .)
		6.	Back door garnish (LH and RH)