Code No.B1458: Rear side impact sensor (LH) communication error
Code
No.B1459: Rear side impact sensor (LH) communication impossible
caution |
If diagnosis code B1458 or B1459 is set in the
SRS-ECU, always diagnose the CAN main bus line.
|
OPERATION
The side impact sensor transmits acceleration data to
the SRS-ECU. The SRS-ECU then determines. if the side and/or curtain air bags
should be inflated, and then sends an ignition signal. The side impact sensor
also diagnoses itself, and sends a diagnosis code to the SRS-ECU if a problem
occurs.
DIAGNOSIS CODE SET CONDITIONS
These diagnosis codes are set if
communication between the side impact sensor (rear) (LH) and the SRS-ECU is
not possible or faulty.
PROBABLE CAUSES
- Damaged wiring harnesses or connectors
- Malfunction of the side impact sensor (rear) (LH)
- Malfunction of the SRS-ECU
|
STEP 1. M.U.T.-III CAN bus diagnostics.
|
|
Use the M.U.T.-III to diagnose the CAN bus
lines.
|
|
Q.
Is the check result normal?
|
|
Go to Step 2.
|
|
|
|
Repair
the CAN bus line (Refer to GROUP 54D, Diagnosis ).
|
|
|
|
STEP 2. Check whether the diagnosis code is reset.
|
|
Check again if the diagnosis code is
set.
|
|
(1)Erase the diagnosis code.
|
|
(2)Ignition: "LOCK" (OFF) position to "ON"
|
|
(3)On completion, check that the diagnosis code is not
reset.
|
|
Q.
Is the diagnosis code set?
|
|
Go to Step 3.
|
|
|
|
There
is an intermittent malfunction such as poor engaged connector(s) or open
circuit (Refer to GROUP 00, How to Cope with Intermittent Malfunction ).
|
|
|
|
STEP 3.Check the side impact sensor (rear).
|
|
(1)Disconnect the negative battery terminal.
|
|
(2)Replace the side impact sensor (rear) (LH) with the side
impact sensor (rear) (RH).
|
|
(3)Connect the negative battery terminal.
|
|
(4)Erase the diagnosis code from memory, and check the
diagnosis code.
|
|
Q.
Is diagnosis code B1448 or B1449 set?
|
|
Replace the side impact sensor
(rear) (LH) with a new one. (Refer to ). Then go to Step 4.
|
|
|
|
Repair the harness wires between
SRS-ECU connector D-25 (terminal No.15 and 16) and side impact sensor
(rear) (LH) connector E-40 (terminal No.2 and 1). Then go to Step
4.
|
|
|
|
STEP 4. Check whether the diagnosis code is reset.
|
|
Q.
Is diagnosis code B1458 or B1459 set?
|
|
Replace the SRS-ECU (Refer to ).
|
|
|
|
An
intermittent malfunction is suspected (Refer to GROUP 00, How to Cope with
Intermittent Malfunction ).
|
|
|