|
COMMENTS ON TROUBLE SYMPTOM |
If the input signal from the sunroof switch is
abnormal, the sunroof input check response signal will not be sent to the
SWS communication line. |
PROBABLE CAUSES |
|
DIAGNOSIS PROCEDURE |
STEP 1. Check the operation condition of the sunroof. |
Check that the sunroof works normally. |
Q.
Is the check result normal?
|
Go to Step 2. |
|
Refer
to GROUP 42 - Troubleshooting . |
|
STEP 2. Connector check: E-02 sunroof switch connector |
Q.
Is the check result normal?
|
Go to Step 3. |
|
Repair
the connector. |
|
STEP 3. Check the sunroof switch. |
Refer to GROUP 42 - Sunroof . |
Q.
Is the check result normal?
|
Go to Step 4. |
|
Replace the sunroof switch. |
|
STEP 4. Resistance measurement at E-02 sunroof switch connector. |
(1)Disconnect the connector, and measure at the wiring
harness side. |
(2)Continuity between E-02 sunroof switch connector terminal
No.4 and body earth OK: Continuity exists (2 Ω or less) |
Q.
Is the check result normal?
|
Go to Step 6. |
|
Go to Step 5. |
|
STEP 5. Check the wiring harness between E-02 sunroof motor switch connector terminal No.4 and body earth. |
|
Q.
Is the check result normal?
|
The
trouble can be an intermittent malfunction (Refer to GROUP 00 - How
to Cope with Intermittent Malfunction ). |
|
Repair
the wiring harness. |
|
STEP 6. Connector check: E-03 sunroof motor assembly connector |
Q.
Is the check result normal?
|
Go to Step 7. |
|
Repair
the connector. |
|
STEP 7. Check the wiring harness between E-03 sunroof motor assembly connector terminal Nos.6, 7, 8 and E-02 sunroof switch connector terminal Nos.6, 3, 5. |
|
Q.
Is the check result normal?
|
Go to Step 8. |
|
Repair
the wiring harness. |
|
STEP 8. Connector check: D-420 ETACS-ECU connector |
Q.
Is the check result normal?
|
Go to Step 9. |
|
Repair
the connector. |
|
STEP 9. Check the wiring harness between E-03 sunroof motor assembly connector terminal No.10 and D-420 ETACS-ECU connector terminal No.59. |
|
|
Q.
Is the check result normal?
|
Go to Step 10. |
|
Repair
the wiring harness. |
|
STEP 10. Retest the system. |
Check that each switch signal is received by
operating the sunroof switch. |
Q.
Is the check result normal?
|
The
trouble can be an intermittent malfunction (Refer to GROUP 00 - How
to Cope with Intermittent Malfunction ). |
|
Replace the sunroof motor
assembly. |
|