DISASSEMBLY AND REASSEMBLY <6B3>



Disassembly steps
<<A>>
 >>C<<
 1.
 Front bracket assembly
<<B>>
 >>B<<
 2.
 Pulley


3.
 Rotor


4.
 Rear bearing


5.
 Bearing retainer


6.
 Front bearing


7.
 Front bracket
<<C>>
8.
 Stator


9.
 Condenser assembly
<<C>>
 >>A<<
 10.
 Regulator assembly


11.
 Brush


12.
 Rubber packing


13.
 Rectifier


14.
 Insulator


15.
 Bushing


16.
 Rear bracket

DISASSEMBLY SERVICE POINTS

<<A>> FRONT BRACKET ASSEMBLY REMOVAL

1.
caution Do not insert the screwdriver tool deep as the stator core could be damaged.
With a screwdriver blade inserted between the front bracket and stator core, pry to separate the stator from the front bracket.
2.If they are hard to separate, lightly strike the bracket with a plastic hammer while prying with the screwdriver.

<<B>> PULLEY REMOVAL
caution Use care not to damage the rotor.

With the pulley side facing up, hold the rotor in a vice and remove the pulley.

<<C>> STATOR / REGULATOR ASSEMBLY REMOVAL

1.Remove 6 installation screws of the stator lead wire, and then remove the stator.
2.Remove 4 installation screws of the regulator to remove the regulator assembly.

REASSEMBLY SERVICE POINTS

>>A<< REGULATOR ASSEMBLY INSTALLATION


After installing the regulator assembly, insert a piece of wire through the hole in the rear bracket while pressing the brush to keep the brush against movement.
note Unless inserting the wire to fix the brush, the rotor installation is difficult.

>>B<< PULLEY INSTALLATION
caution Use care not to damage the rotor.

With the pulley side facing up, hold the rotor in a vice and install the pulley.

>>C<< FRONT BRACKET ASSEMBLY INSTALLATION

After installing the rotor, remove the wire used to secure the brush.