REMOVAL AND INSTALLATION

caution

For the removal of the headlining, refer to GROUP 52B, Service Precautions

and Curtain Air Bag Module <Vehicles with curtain air bag>

Pre-removal and Post-installation Operation

Removal and Installation of Front pillar trim, Centre pillar trim upper, Quarter upper trim (Refer to ).
Removal and Installation of Room Lamp Assembly (Refer to GROUP 54A, Interior Lamp ).

		Removal steps
	1.	Cap <Vehicles with Child Restraint System>
<<A>>	2.	Sunvisor holder
	3.	Sunvisor
	4.	Roof inside assist grip <except for the driver's side on vehicles without curtain air bag>
	5.	Assist grip clip <Driver’s seat side - except vehicles with curtain air bag>
	6.	Assist grip cover
	7.	Roof inside assist grip
	8.	Roof inside assist grip <7 persons>
	9.	Assist grip clip <5 persons>
	10.	Roof ventilator air outlet <Vehicles with rear cooler>
	11.	Tongue holder lid <Three point type seat belt>
	12.	Harness clip
	13.	Headlining clip
	14.	Sunroof lid inner weather strip rear <Vehicles with sunroof>
<<B>>	15.	Headlining
	16.	Roof sub wiring harness
	17.	Assist grip bracket (Front)
	18.	Assist grip bracket (Centre)
	19.	Assist grip bracket (Rear)

REMOVAL SERVICE POINT

<<A>> SUN VISOR HOLDER REMOVAL

Insert the special tools ornament remover (MB990784) into the sun visor holder from its left and right sides to disengage the claws on the sun visor holder sides.

<<B>> HEADLINING REMOVAL

To remove the clip, insert a vinyl cord into a clearance between the clip and the headlining, and pass it around the clip. Then, pull out the clip downwards while pulling the vinyl cord.