REMOVAL AND INSTALLATION <LH DRIVE VEHICLES>


Pre-removal Operation
  • Brake Fluid Draining

 Post-installation Operation
  • Brake Fluid Supplying and Air Bleeding.
  • Brake Pedal Adjustment.





Removal steps


1.
 Brake fluid level switch connector


2.
 Brake master cylinder assembly and brake pipe connection

>>A<<
 3.
 Hose clip

>>A<<
 4.
 Vacuum hose (with built-in check valve)


5.
 Harness clip


6.
 Harness bracket


7.
 Fuel pipe bracket


8.
 Brake master cylinder assembly


9.
 Hose clip


10.
 Vacuum hose


11.
 Snap pin


12.
 Clevis pin


13.
 Brake booster mounting nut


14.
 Sealer


15.
 O-ring


16.
 Brake booster assembly

INSTALLATION SERVICE POINT

>>A<< VACUUM HOSE (WITH BUILT-IN CHECK VALVE)/HOSE CLIP INSTALLATION


  1. Install the vacuum hose (with built-in check valve) with its marking located as shown in the figure.
  2. Install the hose clip within the range shown in the figure.