DISASSEMBLY AND REASSEMBLY

Disassembly steps · Headlamp washer actuator assembly <Vehicles with headlamp washer> (Refer to .) 1. Licence plate garnish <Vehicles with licence plate garnish> 2. Air guide panel 3. Front bumper under grille <<A>> >>A<< 4. Rivets 5. Front bumper extension 6. Front bumper garnish <Vehicles without front fog lamp assembly> 7. Front bumper garnish <Vehicles with front fog lamp assembly> 8. Front fog lamp assembly <Vehicles with front fog lamp assembly> 9. Daytime running lamp and front fog lamp assembly <Vehicles with daytime running lamp and front fog lamp assembly> 10. Daytime running lamp assembly <Vehicles with daytime running lamp assembly> <<A>> >>A<< 11. Rivets 12. Front bumper side bracket upper 13. Front bumper side bracket lower 14. Nut A 15. Grommet 16. Nut B <Vehicles without licence plate garnish> 17. Front bumper face

Use a drill (Φ 4.0 mm) to make a hole in the rivet to break it, and remove the rivet.

Use a rivet tool shown in the illustration to connect the parts with rivets by the following procedures. 1.Insert rivet into the front bumper side bracket and front bumper face. 2.Place the rivet tool over portion C of rivet. 3.While pushing the flange surface of the rivet onto parts to be fixed with the rivet tool, press the handle of the tool. 4.Thin part of portion C of the rivet will cut off and the rivet is fixed in position.