REMOVAL AND INSTALLATION


Pre-removal and Post-installation Operation
  • Removal and Installation of Front Seat Assembly <Double Cab> (Refer to ).
  • Removal and Installation of Rear Seat Cushion Assembly <Double Cab> (Refer to ).
  • Removal and Installation of Front Pillar Trim <Single Cab> (Refer to ).
  • Removal and Installation of Front Pillar Trim, Rear Pillar Upper Trim, Rear Door Upper Trim <Club Cab> (Refer to ).
  • Removal and Installation of Front Pillar Trim, Centre Pillar Upper Trim, Rear Pillar Upper Trim <Double Cab> (Refer to ).
  • Removal and Installation of Room Lamp Assembly (Refer to GROUP 54A, Interior Lamp ).
  • Removal and Installation of Shift Knob <Double Cab> (Refer to GROUP 22A, Transmission Control ).
  • Removal and Installation of Selector Lever Assembly <Double Cab> (Refer to GROUP 23A, Transmission Control ).




Removal steps
<<A>>
1.
 Sunvisor holder


2.
 Sunvisor


3.
 Roof inside assist grip


4.
 Assist grip clip
<<B>>
5.
 Headlining




Removal steps
<<A>>
1.
 Sunvisor holder


2.
 Sunvisor


3.
 Roof inside assist grip


4.
 Assist grip clip


5.
 Assist grip cover
<<B>>
6.
 Headlining




Removal steps
<<A>>
1.
 Sunvisor holder


2.
 Sunvisor


3.
 Roof inside assist grip


4.
 Assist grip clip


5.
 Assist grip cover


6.
 Roof inside assist grip
<<B>>
7.
 Headlining

REMOVAL SERVICE POINT

<<A>> SUN VISOR HOLDER REMOVAL

Insert the special tools ornament remover (MB990784) into the sun visor holder from its left and right sides to disengage the claws on the sun visor holder sides.

<<B>> HEADLINING REMOVAL

1.To remove the clip, insert a vinyl cord into a clearance between the clip and the headlining, and pass it around the clip. Then, pull out the clip downwards while pulling the vinyl cord.

2.To remove the headlining from the vehicle, remove from the rear door (steering wheel side) as shown in the figure. <Double cab>