RADIO AND CD PLAYER REMOVAL AND INSTALLATION

note

When the radio and CD player or display audio are replaced, always turn the ignition switch to the ON position once and then carry out the operation check.

Pre-removal Operation

Centre upper panel assembly Removal (Refer to GROUP 52A - Instrument Centre Panel ).
Outside/Inside Air Selection Damper Control Cable Connection, Air Mixing Damper Control Cable Connection, Mode Selection Damper Control Cable Connection Removal <Manual A/C> (Refer to GROUP 55A - Heater Control Unit ).

Post-installation Operation

Outside/Inside Air Selection Damper Control Cable Connection, Air Mixing Damper Control Cable Connection, Mode Selection Damper Control Cable Connection Installation <Manual A/C> (Refer to GROUP 55A - Heater Control Unit ).
Centre upper panel assembly Installation (Refer to GROUP 52A - Instrument Centre Panel ).

<Vehicles with radio and CD player>

		Removal Steps
	1.	Radio and CD player/Bracket
	2.	Bracket (LH/RH)
>>A<<	3.	Radio and CD player

<Vehicles with display audio>

		Removal Steps
	1.	Display audio/Bracket
	2.	Bracket (LH/RH)
>>A<<	3.	Display audio

INSTALLATION SERVICE POINT

>>A<< RADIO AND CD PLAYER/DISPLAY AUDIO

<Vehicles with radio and CD player>

<Vehicles with display audio>

The connectors, antenna and cables connected to the radio and CD player or display audio are shown in the figure.