|
If the rear wiper does not stop
normally within the predetermined range, the rear wiper
motor or the ETACS-ECU may be defective.
|
|
- Malfunction of the rear wiper motor
- Malfunction of the ETACS-ECU
- Damaged harness wires and connectors
|
![](../../../img/54/AC313481AH00ENG.png)
|
Q.
Is the check result normal?
Go to Step
2.
Repair
the connector.
|
|
Refer to GROUP 51 - Rear
wiper and washer .
|
|
Q.
Is the check result normal?
|
|
Replace the rear
wiper motor.
|
|
|
![](../../../img/54/AC313481AH00ENG.png)
|
(1)Disconnect the connector, and
measure at the wiring harness side. (2)Ignition switch:
ACC
|
![](../../../img/54/AC310507EL00ENG.png)
|
(3)Check the voltage between G-05
rear wiper motor connector terminal No.1 and body
earth OK: System voltage
Q.
Is the check result normal?
Go to Step
5.
Go to Step
4.
|
![](../../../img/54/AC313419AP00ENG.png)
![](../../../img/54/AC313481AD00ENG.png)
|
note |
Prior to the wiring harness
inspection, check intermediate connector G-14
and junction
block connectors C-202, C-210, and repair if
necessary.
|
- Check the power supply line for open or short
circuit.
Q.
Is the check result normal?
The trouble can be
an intermittent malfunction (Refer to GROUP 00 - How
to Cope with Intermittent Malfunction ).
Repair the wiring
harness.
|
![](../../../img/54/AC313421AC00ENG.png)
|
Q.
Is the check result normal?
Go to Step
6.
Repair
the connector.
|
![](../../../img/54/AC313418AJ00ENG.png)
![](../../../img/54/AC313481AD00ENG.png)
|
note |
Prior to the wiring harness
inspection, check intermediate connector G-14,
junction block
connectors C-210, and repair if
necessary.
|
- Check the power supply line for open or short
circuit.
Q.
Is the check result normal?
Go to Step
7.
Repair
the wiring harness.
|
|
Check that the rear wiper auto stop
function works normally.
|
|
Q.
Is the check result normal?
|
|
The trouble can be
an intermittent malfunction (Refer to GROUP 00 - How
to Cope with Intermittent Malfunction ).
|
|
|