|
- Remove the washer tank assembly with the washer hose
attached.
Then fill the washer tank with water.
- Check to see that the washer fluid is vigorously
sprayed when connecting the positive
battery terminal to terminal number 2 and terminal
number 1 to earth.
|
|
|
Check the windshield washer switch
from the ETACS diagnosis codes for proper operation
(Refer to GROUP 54A, ETACS  ).
|
|
| note |
Use special tool Adjustment
tool, washer nozzle (MB992326) to adjust the
splashing points
of the nozzle.
|
|
|
| caution |
Adjust the splashing position
within the specified adjustment
range, otherwise the windshield cannot be washed
properly.
|
1.Use special tool Adjustment tool, washer
nozzle (MB992326) to adjust the splashing
points of the nozzle.
2.Insert the jet type washer
nozzle adjusting side of the special tool Adjustment tool,
washer nozzle (MB992326) into the injection part of the
washer nozzle as shown in figure (A).
|
|
3.Move the special tool
Adjustment tool, washer nozzle (MB992326) up and down to
adjust
the angle of the washer nozzle as shown in figure
(B).
|
