![](../../../img/51/ACB03348AB00ENG.png)
|
Inspect the rear wiper motor by
disconnecting the harness connector with the motor attached
to the vehicle.
|
|
Connect the battery to the rear
wiper motor to inspect the motor operation as shown in
the illustration.
|
|
- Connect the battery to the rear wiper motor as shown
in the illustration.
- Disconnect the battery in the middle of the motor
rotation and check to see that
the motor stops.
- Reconnect the battery.
- Check to see that the rear wiper motor runs and then
stops at the automatic stop
position.
|
![](../../../img/51/ACB05880AB00ENG.png)
|
1.The rear washer motor must
be checked with the washer tank installed and the washer
fluid
filled. 2.Connect the battery to the washer motor
connector as shown. Check that the washer
motor delivers washer strongly to the rear washer hose
side.
|
![](../../../img/51/AC900637AC00ENG.png)
|
note |
Use special tool Adjustment
tool, washer nozzle (MB992326) to adjust the
splashing points
of the nozzle.
|
|
|
1.Use special tool
Adjustment tool, washer nozzle (MB992326) to adjust the
splashing
points of the nozzle.
|
![](../../../img/51/AC900956AC01ENG.png)
|
2.Insert the jet type washer
nozzle adjusting side of the special tool Adjustment tool,
washer nozzle (MB992326) into the injection part of the
washer nozzle as shown in figure (A).
|
![](../../../img/51/AC900958AF00ENG.png)
|
3.Move the special tool
Adjustment tool, washer nozzle (MB992326) up and down to
adjust
the angle of the washer nozzle as shown in figure
(B).
|
|
The rear wiper and washer switch
can be checked for proper operation by confirming ETACS
diagnosis code. (Refer to GROUP 54A - ETACS )
|