|
|
Gently lift and remove the roof
drip moulding. If there is any double-sided tape remaining
on the roof drip moulding, remove according to the following
instructions.
|
|
|
<Remove double-sided tape
remaining on the body surface>
|
|
|
1.Attach protection tape all
the way along the edges of the double-sided tape which is
still adhering to the body.
|
|
|
2.Scrape off the
double-sided tape with a resin spatula as much as
possible.
|
|
|
3.Peel off the protection
tape.
|
|
|
4.Wipe the body surface and
clean it with a rag moistened with Parts Cleaner (MZ100387
or equivalent).
|
|
|
<Remove double-sided tape
remaining on roof drip moulding and adhere double-sided tape
(when re-using roof drip moulding)>
|
|
|
1.Scrape off the
double-sided tape on the roof drip moulding with a resin
spatula as much as possible.
|
|
|
2.Wipe the roof drip
moulding surface and clean it with a rag moistened with
Parts Cleaner (MZ100387 or equivalent).
|
|
|
3.Remove only a small
portion of the residual adhesive.
|
|
|
4.Adhere the double-sided
tape as specified on the roof drip moulding.
|
|
|
Use the special tool ornament
remover (MB990784) to pry out the front delta
garnish.
|
|
|
1.Use the parts cleaner
(MZ100387 or equivalent) wipe off the adhesion surface to
decrease it.
|
|
|
2.Apply the specified primer
to the double-sided adhesive tape surface. Then dry it off
sufficiently.
Specified primer: 3M N200 or
equivalent
|
|
3.When the roof drip
moulding is reused, apply an adhesive tape to
it.
Double-sided tape: Commercially-available
products a (8 mm width, 10 mm length and 1.2 mm
thickness), b (14 mm width, 8 mm length and 2.0 mm
thickness)
|
|
4.When the roof drip
moulding is reused, apply a backing paper to the tape B as
shown.
|
|
5.Bend the backing paper as
shown.
|
|
6.Insert the tip of the roof
drip moulding into the gap between the rear window glass and
the body panel with the backing paper bent.
7.Pull
out the backing paper.
8.Install the roof drip
moulding.
| note |
If the double-sided tape is
difficult to affix in cold temperature, etc.,
warm the bonding surfaces of the body and roof
drip moulding to about 40- 60°C
before affixing the tape.
|
9.Firmly press in the roof drip
moulding.
|
