![](../../../img/51/ACF01772AA00ENG.png)
|
Inspect the rear wiper motor by
disconnecting the wiring harness connector with the motor
attached to the vehicle.
|
|
Connect the battery to the rear
wiper motor to inspect the motor operation as shown in the
illustration.
|
|
- Connect the battery to the rear wiper motor as shown
in the illustration.
- Disconnect the battery in the middle of the motor
rotation and check to see that the motor
stops.
- Reconnect the battery.
- Check to see that the rear wiper motor runs and then
stops at the automatic stop position.
|
![](../../../img/51/ACF01771AB00ENG.png)
|
1.The rear washer motor must
be checked with the washer tank installed and the washer
fluid filled. 2.Connect the battery to the washer
motor connector as shown. Check that the washer motor
delivers washer strongly to the rear washer hose
side.
|
![](../../../img/51/AC609144AB00ENG.png)
|
Check continuity between the switch
terminals.
|
Switch
position
|
Tester
connection
|
Specified
condition
|
OFF
|
-
|
Open circuit
|
Rear wiper
switch
|
6 - 4
|
Continuity exists (2
Ω or less)
|
Rear washer
switch
|
6 - 5
|
|
|
|
The rear wiper and washer switch
can be checked for proper operation by confirming ETACS
diagnosis code. (Refer to GROUP 54A - ETACS )
|
![](../../../img/51/AC900637AC00ENG.png)
|
note |
Be sure to use the special
tool, washer nozzle adjustment tool (MB992326)
to adjust the splashing points of the
nozzle.
|
|
|
1.Use the special tool,
washer nozzle adjustment tool (MB992326) to adjust the
splashing points of the nozzle.
|
![](../../../img/51/AC900956AC00ENG.png)
|
2.Insert the jet type washer
nozzle adjusting side of the special tool (MB992326) into
the injection part of the washer nozzle as shown in figure
(A).
|
![](../../../img/51/AC900958AE00ENG.png)
|
3.Move the special tool
(MB992326) up and down to adjust the angle of the washer
nozzle as shown in figure (B).
|